Use the electric tug only with a suitable hook and check that it is in good
condition. If in doubt, consult your distributor.
Verify that the used are in good condition and can be attached
Watch out for your own and others’ safety when connecting and disconnecting the .
Beware of clamping hazards with electrically powered equipment.
Do not connect loads that are heavier than the maximum allowable towing weight of the electric tug. For more information, refer to the VDI
table.
Do not connect loads that are not suitable for the hook fitted. If in doubt, consult
your distributor.
Always check that the hook is
secure before driving off. If there is a locking device, make sure it is locked.
When driving on slopes; ensure that the hook and load are suitable for this purpose. If in doubt, consult your
distributor. Do not connect or disconnect the load on a slope.
Slow down gradually before driving down a slope.
Only drive on a slope with half speed by using the turtle mode.
Never park on a slope.
Do not turn on a slope.
Make sure the slope is clean and not slippery. The surface should be level and clear of
obstacles.
Never exceed the maximum incline/weight combination as shown in the VDI
table.
